Please Contact PressEnter! to get you DSL
account activate.
(715) 246-7060
To Configure your SpeedStream DSL Modem
1). First, you need to install DSL filters on all
of the equipment that uses the same line as your DSL. (This includes:
phones, fax machines, Direct TV, Security systems, etc.)
2). Now locate the Network interface card (NIC)
on the back of your PC, and plug one end of the network cable that
was provided in the Modem Kit into the back of the PC. Connect the
other end into the LAN port of the DSL Modem. Plug in the DSL line
(phone cord) between the DSL port in the back of the modem, and
your wall phone jack. There should not be a filter
on this line. And lastly, plug the power adapter into the modem.
Wait 2 minutes for the modem to boot up. Now reboot your PC.
3). Once your PC is up and ready
to go, call PressEnter! To activate your account for DSL(715-246-7060).
Once this has been done, open up a browser window (example: Internet
Explorer) and click the stop button. Then enter this text: http://192.168.254.254
into the address bar and press enter.
You should see to a screen like this:
4). Enter a username and password for the
admin account on the Modem. (Make sure you choose something that
you will remember, and write it down.) After you enter the username,
password and confirm the password, click on the button for "Require
admin login to access entire web site", and click on "save
settings".
5). Next click on Advanced Setup, (on the left
pane of the page,) and click on Host, you will see a page that looks
similar to this:
6). In Host Name, enter you PressEnter login
name. (This is usually the first part of your email address.) Click
on save settings, and it will then display a message that the modem
needs to reboot. Click the reboot button and the modem will restart.
(This will take approximately 45 seconds).
7). Click on the Login (on
the left pane of the page.) And it will display a page similar to
this.
8). In the username area, enter your PressEnter
username. (Again this is usually the first part of your PressEnter
email address). Next, enter your PressEnter password in the password
area. Click on the "Show options" button, and this will
bring up a page asking for a username and password for the Modem.
(Enter whatever you used for the admin's username and password in
Step 2). After you enter that, place a mark in the box labeled "Auto-Connect
on Disconnect." This will allow your modem to automatically
re-connect itself after power failures, or if your modem loses its
connection. Verify "Save Settings on Connect" is checked.
9). Click on the "Connect" button and
you should see a page that looks like this:
10). If the text underneath the "Point
to Point Connection Summary" line is printed in green, you are
connected and ready to use the Internet.
If you have any questions or problems, please feel free to contact
PressEnter's technical support at (715) 246-7060.
Thank you, and enjoy your
new, high-speed Internet service!
|
Printer Friendly Page
